Turrbie@aol.com wrote:
In a message dated 6/7/99 11:08:27 AM Eastern Daylight Time,
rotaryeng@earthlink.net writes:
Brian D. Cain wrote:
>
> I am not running the race-cleared, multi-window rotor bearings. I am
> Still, even though I don't like it, am running the standard stationary
gears
> Out of the '87/'88 blocks as well as their respective main bearings. The
> Rotor bearings are standard, as well, although all four bearings are
brand-
new
> (were 6,000mi ago). I use an aftermarket, Autometer mechanical 0-100
oil
> pressure gauge that I absolutely trust. =)
>
> I am currently running 20W50 motor oil in the crank.
Just out of curiosity, I called Jim Tanner at Racing Beat to check on a set
of end housings they were working on and to get some more information on the
e-shaft jet modification. I described Brian's and my own personal results.
Besides being very direct in saying that the mod was unnecessary except in
race applications, Jim said that the oil pressure loss should be minimal at
idle and that Brian's engine is probably has something else causing the loss
in pressure. Maybe the front oil main o-ring has partially sheared. At the
moment, I can only say that the modification hasn't shown any ill effects
with my engine. I'll take a pressure reading from my engine with a higher
resolution gauge when I have the time and report those figures.
IMHO: To those who gain comfort from super high oil pressures, this comes at
the price of the power consumed to produce it. I haven't any of my data books
in front of me at the moment but I do recall that the main goal of a
pressurized oil system is to provide enough pressure to maintain the
hydraulic wedge between the bearings and enough flow volume to effectively
carry heat away from the lubricated surfaces. More pressure and volume beyond
a comfortable safety buffer is a waist of energy. The wasted energy can
amount to several HP.
Bruce Turrentine
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org