Subject: The E-shaft oil jet modification 'thing'
From: Paul
Date: 6/7/1999, 5:29 PM
To: zz

Brian D. Cain wrote:

Now that you mention it Bruce, I did notice a little smoke
coming out of the pipe earlier on the way home.  I've been
known to run the stock Ser 5 turbocharger "past its limits"
on occasion, including some 13psi manifold pressure runs
during my enthusiastic rush-hour drive to work this morning.

Idiots on the road; I swear.  I say, "get in your spot in a hurry
and stay there.".. so I did.  =)

I've been running that turbocharger hard for the past several
months and the oil seal in the turbine housing section could
be going south as far as I know.  I don't have any visible,
external leaks anywhere and I currently run a baffle plate
on the oil pan so I don't believe pickup or spill is involved.
I got just a 'hairbit' of smoke.  I did, however, lower the oil
cooler about 2" from its base mounting point last year because
of an excess in oil cooler line lengths.  That might be one problem
if the oil is getting too hot and thinning itself out under thermal
breakdown or something ... I'll get an oil temperature gauge here
in the next couple of weeks (among other things) and check it
out.

Otherwise, all in all, the engine is still as silver, blue, and shiny
as it was the day I installed it w/o any puddles on the garage floor.

B

-] Brian D. Cain, FC Motorsports. bcain@waymark.net
-] 1988 Mazda Rx7 Turbo II/FC3S -- 13.86 - 104.08mph.
-] Dallas, TX   (214) 885-8227 ICQ#: 1733105
-] http://homepages.waymark.net/~bcain
-] http://rotary.simplenet.com/fcm/intro.html

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org