Subject: Grooved rotor housings.
From: Paul
Date: 6/8/1999, 12:27 PM
To: zz

Todd Carrico wrote:

JMLBlues@aol.com wrote:
 >
 > Enlarging the water jacket in the high heat flux zone (around the spark
 > plugs) will be counterproductive. Heat transfer is a function (don't
remember
 > the exponent) of coolant velocity. A larger cross sectional area will
reduce
 > the velocity. You basically want to have the coolant velocity as high as
 > possible without suffering cavitation erosion, a practical limit we used
was
 > around 12 fps.
 >
 > Jon Lauter
 > Rotary Power Marine Corporation

Given this if the stock water pump is good to 7000 or 7500 it might be a
good idea
to speed it up with a smaller pulley if you are going to use a 2:17 PSRU
and a max RPM of 6300 or so.

Paul Lamar

Jon,
I would think that what you are shooting for is max heat transfer.

Thermal conductivity, surface area are also important.  Can you get into a
situation where you are moving the fluid so fast that it doesn't transfer
enough heat?
Todd 


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org