This grooving operation would be an ideal
application for an NC mill. You could use about a 1/2 cutter
1/8 wide with radiused corners and a 3/16 inch shank.
That would give you about a .156 inch deep slot.
A 1/4 inch shank would give a 1/8 inch deep slot of course.
Once the program was written set it up and let it run.
My guess is with two cycle apex seal oil it is probably a waste of
time and money :-) It could reduce housing shrinkage however.
In the latter case only two slots near each side would be necessary
to relieve the thermal compressive stresses on the rotor housing.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org