Subject: Grooves in rotor housing water jackets.
From: Paul
Date: 6/8/1999, 3:04 PM
To: zz

Jeff Spitzer wrote:

At 11:28 PM 6/7/99 -0700, you wrote:
Paul Yaw wrote:

Down to the steel liner?  The aluminum is nearly a half inch thick.
This mod is normally done with a 3/16" ball end carbide burr.  Is there
someone out there who cuts all the way to the liner?

PY

Its about a half inch at the bump and about .4 inches everywhere else.
The steel liner with teeth is about 0.08 - 0.1 inches thick. That leaves
about 0.3 inches for a max depth slot.

I'm a little concerned here, Paul.  Let's be clear about "what has been
done for ages by racers" and "what Paul Lamar thinks is a reasonable
extension of this".  If PY has never heard of cutting all the way to the
liner then I contend that it is not normally done. Let's keep the facts
straight.  What does racing beat do?  Who else cuts all the way to the
steel?  Please stick with the facts if we're going to do a service here.

Jeff Spitzer

Racing Beat does a shallow groove as indicated by the tool Paul Yaw
mentioned. It is true. I advocate a deeper groove for the reasons
stated.
Mainly to relieve the compressive stress due to thermal expansion.

Paul

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org