Subject: Grooves in rotor housing water jackets.
From: Paul
Date: 6/8/1999, 10:48 PM
To: zz

Paul Yaw wrote:

Paul wrote:

Bulent Aliev wrote:

Hi Paul,
I wander if a Dremmel tool has the guts (Power)to do the grooves? I have
small router attachment for it, that can make this job fairly easy for
people without much experience with free hand grinding like me. I have
used it on plastic and does a very good job.
Bulent

I am sure it would work Bulent. Might be a question of time.

Paul Lamar

If you decide to do this, invest in the appropriate burr.  If you use a
double cut, with many flutes, you will spend most of your time picking
aluminum out of the tool.  Get one designed for cutting aluminum.  6
flutes, single cut.  The job will go much quicker.  Also, use a lot of
WD-40, or some other lubricant to keep the burr clean.  Use low speed
when grinding aluminum.  It usually takes me about three miserable
hours.  Another note for those of you who don't do much grinding is to
put plastic bags over your feet, and duck tape them to your pants to
seal your shoes.  This might sound silly now, but you will change your
mind after pulling slivers from your feet.

PY

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org