Subject: Picture of Grooves in rotor housing water jackets.
From: Paul
Date: 6/8/1999, 3:05 PM
To: zz

Jeff Spitzer wrote:

At 07:31 AM 6/8/99 -0700, you wrote:

Good idea Bruce. I could not find it in the Mazdatrix catalog but
here is a picture out of the Racing Beat Catalog.

grooves.jpg

Paul Lamar


This appears to show rounded bottom grooves approximately .1" deep which is
what you would get if you used the 3/16 ball burr like PY described.

Jeff Spitzer

You can tell that from the picture? :-)

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org