Jeff Spitzer wrote:
At 01:27 PM 6/9/99 -0700, you wrote:
I agree with all this and there is one other factor heating the
apex seal and there is evidense it is the most important factor. When
the exhaust port opens there is a squirt of high temperature
exhaust gases passing by the apex seal. Also the trialing apex
seal is sweeping the hot gases before it at this point in time
until it too reaches the exhaust port and is subjected to a new
blast of hot gases from the next rotor flank.
The sides of the apex seals are rubbing just as fast as the center
but the center runs much, much hotter as you can see from this chart.
Ah yes, I had forgotten about this one. How right you are. This is a
MAJOR source of apex seal heating. Now, what was the argument about the
oil cooling the apex seal? And how does that relate to the center running
hotter? ;-)
Jeff Spitzer
Mazda injects the oil into the center of the rotor housing about where
the intake ports are. IMHO this puts the oil right where it
is needed to cool the center of the seal before it gets a chance
to be heated up yet again in the combustion cycle.
I am walking out the door right now!
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org