Subject: Grooves in rotor housing water jackets.
From: Paul
Date: 6/9/1999, 12:55 PM
To: zz

Mike Wills wrote:

At 10:48 PM 6/8/99 -0700, you wrote:
Paul Yaw wrote:

If you decide to do this, invest in the appropriate burr.  If you use a
double cut, with many flutes, you will spend most of your time picking
aluminum out of the tool.  Get one designed for cutting aluminum.  6
flutes, single cut.  The job will go much quicker.  Also, use a lot of
WD-40, or some other lubricant to keep the burr clean.

I recently used an air powered die grinder with a 1/4" double cut burr to
remove some material from an intake manifold. As you say, I spent a lot of
time cleaning the burr. Tried various lubricants before finally trying
beeswax. A friend who is a machinist told me to give this a try. Sold in
small solid blocks. Spin the burr up against the beeswax for a couple of
seconds until the flutes fill and then you can grind away on your aluminum
without plugging. And no mess like you get with a liquid cutting oil.
Worked for me.

Mike Wills


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org