Subject: How to make a one rotor engine e-shaft
From: Paul
Date: 6/9/1999, 8:25 AM
To: zz

Paul Yaw wrote:

Paul wrote:

Gerry Hess wrote:

Hi Virg;
The bolts were made by me and lost, and Paul Yaw made me another set. Our
thoughts were that the rolled thread is obviosly stronger,  but in a single,
you have halved the load on the tie bolt. Also, the original rolled thread
is retained and used for torquing. Only .5" of the other end is threaded and
a 3/8 nut installed and tacked to form a bolt head.
This was not very clear in the post I sent, as I was in a hurry(daughters
grad), and I just pasted in some crypic notes made to myself as info for oil
spray holes.  The hole size, etc, by the way is exactly what NASA did in
their work.
Gerry

If you do this, don't forget to put all of the "bolts" in the lathe and
turn down the backside of the nut to square it with the shank.  These
mate with rubber/steel sealing washers, and if they do not mate
properly, you could leak water.  I didn't think to do this until I
already had the engine assembled.  I had to remove all the tension
bolts, turn them down, and then replace the sealing washers with new
ones.  Oops!

PY

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org