Subject: Picture of Grooves in rotor housing water jackets.
From: Paul
Date: 6/9/1999, 8:52 AM
To: zz

Todd Carrico wrote:

 > > Brian D. Cain wrote:
 > > >
 > >
 > > Excellent picture.  So, the idea to 'groove' the surfaces of those
 > > particular jackets rather than do the brute force 'bigger is better'
 > > thing by making the passages larger... which wouldn't do much else
 > > unless the rest of the system isn't an hourglass shape...
 > >
 > > >
 > > I don't understand the principle behind the grooved over flat surface
 > > thing.
 > > >
 > > > B
 > > >

 > >Paul wrote:
 > > The short answer Brian is; it improves the heat transfer compared
 > > to the bigger is better approach. Trust me :-)
 > >
 > > For your application I don't think you will notice the difference.
 > > Not unless you blast across West Texas flat out for hours on
 > > end that is :-)
 > >
 > > Paul

  Alfonso Lebron wrote:
 >
 > The principle behind the grooved over flat surface is based on the
 > increase of surface area in contact with the coolant. This way, more
 > coolant is exposed to the combustion chamber external surfaces thus
 > allowing more heat transfer, I think. Same principle applies whenever
 > there is transfer across a barrier, be it heat exchange, filtration....
 > Have you noticed how grooved are most of the air filters?
 >
 > Alfonso Lebron
 >

Paul is advocating deeper groves to releive compression caused by local
overheating in this area.   If the modification actualy allows the housing
to transfer enough heat to keep the housing from warping, then it would not
be neccessary to make deeper grroves.  If it doesn't in our application,
then we should consider the deeper groves that would prevent the housing
from warping shold the overheat occur.  You would only need a couple of
these deeper grooves.  It obviously needs testing, and it needs to be tested
in our applicaiton.  This thread started as a result of an actual problem.
Correct?  If so, is this likely to occur again?  If so, then we should
deffinatly try to come up with a fix.  What are our options besides deeper
grooves?

tc


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org