Subject: The E-shaft oil jet modification 'thing'
From: Paul
Date: 6/9/1999, 8:50 AM
To: zz

Turrbie@aol.com wrote:

In a message dated 6/7/99 8:20:57 PM Eastern Daylight Time,
rotaryeng@earthlink.net writes:

l
 > cooler about 2" from its base mounting point last year because
 > of an excess in oil cooler line lengths.  That might be one problem
 > if the oil is getting too hot and thinning itself out under thermal
 > breakdown or something ... I'll get an oil temperature gauge here
 > in the next couple of weeks (among other things) and check it
 > out.
 >
 > Otherwise, all in all, the engine is still as silver, blue, and shiny
 > as it was the day I installed it w/o any puddles on the garage floor.
 >
 > B

Brian,
86-88 engines, especially those which have had the front cover removed and
the gasket replaced with Mazda's service gasket, have a nasty habit of
shearing the oil main O-ring between the front end housing and the front
cover. The replacement gasket is too thick to crush the O-ring properly. This
happens more often on vehicles that are driven hard. The only symptoms
associated with this failure is a moderate to major loss in oil pressure. The
escaping oil simply returns to the pan.
Bruce T


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org