Subject: The E-shaft oil jet modification 'thing'
From: Paul
Date: 6/9/1999, 10:03 AM
To: zz

Brian,
86-88 engines, especially those which have had the front cover removed and
the gasket replaced with Mazda's service gasket, have a nasty habit of
shearing the oil main O-ring between the front end housing and the front
cover. The replacement gasket is too thick to crush the O-ring properly. This
happens more often on vehicles that are driven hard. The only symptoms
associated with this failure is a moderate to major loss in oil pressure. The
escaping oil simply returns to the pan.
Bruce T


Brian D. Cain wrote:

Ohhhh yeah.. I've got *personal* experience with this one, Brucey'.

Do you know why I had to rebuild 6000miles ago?  :-p

I have ZERO oil pressure up until about 3krpm where it would rise
To a killer 15psi.  The exhaust was also spewing blue smoke out the
Back.  When I removed the front cover after being suspicious of that same
Front cover pickup o-ring, I found half of the o-ring barely hanging between
The front iron casting and the front cover and the other half in the oil
Pan.  The o-ring was as hard as steel, too.

When I replaced it, I had oil pressure in the high 70's (76-79) when cold;
All the while blowing billows of white, industrial smelling smoke out the back,
Consuming as much as a quart an HOUR at idle.

Perhaps Hayes Rotary should make a more bullet-proof front cover o-ring...

You're right, however, about it becoming dislodged; especially during
Installation.  I usually gunk the thing up in HiLamar (!) when I put the front
Cover on.

B


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org