MAR34807@aol.com wrote:
Mario, in stock form from the factory in the car the 20B is rated to give 299
hp at 4000 rpm (turbo model). In stock auto form it has a 7000 rpm redline,
the hp dropping off a little (not much) at 6000 rpm. This with all the auto
restrictions existing in Japan~laws there limiting car output to 300hp max or
so is the only reason this thing isn't higher. In flight ready form with an
after-market turbo, no exhaust restrictions and no smog, I would not be
surprised to see it get up to 400 or more hp. The car's stock torque is also
flat 3000 to 6000 rpm, don't have the figures readily handy but can send it
The starter location in the cars is about 7 o'clock when viewed from the
tranny side. Most Cessnas I've owned had the starter at 7 to 8 o'clock
viewed from the pilots seat (4-5 o'clock from the front). I do not know what
is the best location but will put that to the Mazda aircraft list to respond
to you directly. It would depend on how the engine mount and accessories were
mounted around the engine-an individual's choice.
You said:
All the measurement for the Mazda 13-B/20-B direct bolt-on bell-housing is
done. We are waiting for the pattern. It should be ready within 2 weeks.
Units should be ready within 6 to 8 weeks from now.(6-10-99 now)
We don't make M-450 VP for Mazda. Two other persons ordered the M-300 VP to be
use on 20-B. I think this is the right choice.
You do not have to send a deposit until I give you a date of delivery.
The starter position is going to be
located at 6 o'clock. We supply standard constant speed flanges.
M-300 VP is 4500.00 $ CDN + shipping and customs fee if there is.
To figure the price in US we have to convert with the daily exchange rate.
Today rate is 1.4674. So your price is 3066.00 $ US + shipping.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org