The blue hose is a bypass so when the throttle is slammed open
the engine air bypasses the super charger. The black hose
goes to the intercooler and the large aluminum pipe carries cooler
air from the intercooler to the intake manifold.
The coolant pressure sensor in the lower left corner of the picture
will be securely mounted and a flexiable hose used to
connect to the radiator with an aluminum fitting.
The current set up puts high bending stresses on the roots of
the threads of the brass fitting screwed into the radiator.
If a resonent situation were to occur this fitting would soon
crack and break off dumping all the coolant overboard.
The two silver boxes mounted on the firewall are stock
Mazda ignition modules.
The small alternator is from some small car as I recall.
Also visable is the, soon to be changed, aluminum pipe
carrying high pressure engine oil to the Ross gearbox.
Tom had a real neat idea for the front motor mounts.
Since the stock Mazda RX7 mounts carry most of the load
in a bed mount arrangement the front mounts are rubber freeze
plug repair units. Cheap and readily available. You can not
see them in this picture of course.
In dusty conditions Tom would need an air filter. None
is presently installed.
The welded aluminum air chamber bolted to the rootes blower
would be a good candidate for a future internally streamlined
composite air box. A slight improvement in volumetric efficiency
might result.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org