JMLBlues@aol.com wrote:
The supercharger bypass system looks similar (conceptually) to what we use on
our model 240si marine rotary engine. The bypass is *strongly* recommended by
Eaton. A roots blower is a positive displacement pump. When a non-bypassed
roots-type supercharged engine is operating at light loads, the supercharger
is still trying to pump its full displacement volume. This is a parasitic
loss which is entirely unneccessary. The Eaton bypass allows the excess air
from the supercharger outlet to return to the supercharger inlet, thus
letting it pump at a low delta p. (Remember from thermo that work is required
to move a volume of gas across a pressure rise.) When the throttle is slammed
open, the bypass closes so that the supercharger starts earning its keep. In
a marine application, there is plenty of time in the duty cycle on the prop
curve where the blower is freewheeling. It's a big efficiency improver. I ran
a test without the bypass, and the inlet air temp was much higher even at
light load.
Jon Lauter
Rotary Power Marine Corporation
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org