Subject: Tom Jordans supercharged 13B
From: Paul
Date: 6/19/1999, 1:37 PM
To: zz

Todd Carrico wrote:

The rootes supercharger is on the left rather hidden.
The intercooler is mounted horzontally below that.
The intercooler runs warm even at 3700 RPM static
indicating it is doing its job. The red box on
the wing root is the temporary blower pressure gage
mount.

The modified stock Mazda throttle body is just at
the rear of the blower and along side the Ross bell
housing.

The engine uses a stock Mazda bed mount using stock late Mazda
cast iron motor mount bracket. Some weight will be reduced in the
future by changing these to aluminum. It also uses stock
Mazda rubber motor mounts.

The down pipe for the muffler comes out rather close to the
prop and makes a strange sound every time a blade goes by
and an exhaust pulse is coming out of the muffler. Since
the PSRU is 2.17 to one and not an exact integer multiple
of the engine RPM it is not possible to "clock" the prop.
Clocking the the prop is done on most direct drive pusher
engines to prevent the exhaust gas pulses from
impinging on the prop blades. Tom will shorten the exhaust
pipe and perhaps drill some holes in it to reduce this effect.

The engine is quieter than an equavalent aircraft engine.
There is also a lot less vibration.

The oil cooler with electric fan is below the muffler.
The water rad is mounted below the engine at about a 30
degree angle fed by a P51 type belly scoop. The oil
cooler and intercooler will be fed by arm-pit scoops.

Tom will change the aluminum pipe feeding engine oil pressure
to the Ross gear box.

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

Does SUMMIT racing have a problem with the advertisement?

Also, is that the famous Paul Lamar tangential muffler?

I don't see any firesleeve.

tc

Hey tangential mufflers were invented by Doctor Porsche
for the VW as far as I can tell. They may go back further than that.

To answer the question.. No! The output pipe goes all the way
through the muffler and it has a bunch of holes drilled in
it. When the engine is at WOT at 3700 RPM you can stand behind
the airplane and look inside. The guts run brite orange.

Despite not being the right kind of muffler it still works great :-)
Tom used a flame cut half inch thick exhaust flange and that mother
is heavy. He could probably save ten pounds by going to 
four bolt flanges. 

tomsflan.jpg 

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

tomsflan.jpg