Subject: Perry Mick 13B ducted fan EZ
From: Paul
Date: 6/22/1999, 2:05 AM
To: zz

Jeff Spitzer wrote:

Vance and Emily Jaqua wrote:

Expanding sub sonic flow behind the prop as suggested by
Marc cannot possibly be the right thing
to do. You would be reducing exit velocity from
the vehicle and thrust was still M dot delta V the
last time I looked - Vance


I'm a little rusty on duct design bet let me offer this.  Because the
velocity across the fan/prop disk is held constant by continuity
requirements, the power input MUST show up as a rise in static pressure.

You have two choices in how to use the static pressure rise.  If the outlet
area is the same as the fan area then the pressure downstream of the fan
will be essentially freestream.  This will induce a lower pressure upstream
of the fan.   IIRC, this favors static conditions but hurts high speed
operation.  If the duct is constricted after the fan to *expand* the flow
then the pressure downstream of the fan (but before the exit) will be
higher than freestream.  If the duct constriction is about right then the
air will not accelerate into the inlet (due to a lower than freestream
pressure) and will arrive at the fan at nearly freestream static pressure.

There is then a static pressure rise across the fan and proper acceleration
downstream.  Again, IIRC, this is the proper setup for high speed flight.
The ideal scenario for both static and high speed includes variable pitch,
variable exit, and least important, variable lip.  BTW, Vance, expanding
subsonic flow speeds it up not slows it down.

Jeff Spitzer


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org