Jeff Spitzer wrote:
Peter Johnson wrote:
Hello everybody. My two (Canadian) cents worth on the topic of grooving
the water jacket. Removing material between the combustion chamber and the
cooling system will of course help to transfer heat. But, as anyone in
industry will tell you, 'turbulating' a heat transfer fluid, such as glycol
in an engine, in a heat exchange system will do much to improve the
efficiency of the system. This is due to more of the coolant coming into
contact due to it being made turbulant. The first thing I thought of when
I first read about grooving the housings was this, I was kinda surprised to
hear that nobody had picked up on it.
To this end, I feel a similar improvement in heat transfer could be
achieved by installing a small vane or two in the coolant rotors. This
would not take much, a lot are not needed, and they need not be large.
Anything which would 'mix up' the coolant while it was flowing would help.
To provide an example, if you take a look at the large epoxy kits which
come in tubes designed to be used with a caulking gun, the mixing of the
epoxy is done in tubes which have vanes which alternate in direction
therefore mixing up the epoxy.
I agree that properly done this could be a better solution than grooving.
I have no idea right now whether this would be easy to do *right*.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org