I just witnessed a demonstration of the ultrasonic crack detector in
operation on my crankshaft. I am impressed and amazed. This device can
find the tinest flaw. It is first used on a calibration bar
with a very small notch in the corner barely visable with
the naked eye. This test notch was done with a laser.
There were a lot of cracked cranks that got put back in service I am
sure before this technology became available. Magnaflux would never have
found it.
In the case of this AD the crack is subsurface. Apparently the nitride
layer is so hard and brittle that a crack can start between the nitride
layer and the base metal. The damper pin pushings are pressed in place
after the nitride process and if it is not done just right a sub surface
crack can form. Is is not possible to put the bushings in before the
nitrided process because of the high temp required would melt the
bushing bearing material.
In this case the crack propagates rather quickly and the crank will fail
in a catastrophic manner blowing out the top of the crankcase and
blowing one of the mags off the engine.
I am glad Continental found this before I got the brand new engine in my
airplane and tried to fly with it. My engine was OK fortunately. No
cracks. Never-the-less this experience has scared me a little. I feel I
would be safer with a rotary engine.
One out of 13 cranks made in 1998 and tested so far had cracks. Seven
engines have failed. One injury. Continental is spending big bucks to
solve this problem. They are paying $700 to those people disassembling
and reassembling the engine and they are supplying all needed parts and
materials. They are flying people around the country to check the cranks
with the ultrasonic tester. 3500 cranks were made in 1998. So far 2500
have been checked.
Forget cranks. Eccentric shafts are the way to go in aircraft engines.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org