Subject: Hot fuel in header tank
From: Paul
Date: 6/26/1999, 11:52 PM
To: zz


If you recall, I was advocating returning the fuel to the main tanks to avoid
excessive heating of the fuel in the header tank.  The problem is that if the
fuel gets too hot pump cavitation may result.  I was digging through some
excel files and found an old one that dealt with fuel heating.  I adapted it
to our discusion and made some plots.  The premise is a gravity feed system
which keeps a 5 gallon header tank full.  The fuel in the wing tanks and
header tank start at the same temperature.  The only heat transfer is 100
watt input from the combination of fuel pump and fuel lines in the engine
compartment.  The fuel that is burned is replaced with fuel at the initial
temperature.  Both plots refer to temperature rise because the starting
temperature is irrelevant (ignoring the reality of heat transfer in the
lines).  Also note that some heat transfer could be expected through the tank
walls but is not accounted for.

My conclusion is that a 5 gal header may be fine even on a hot day as long as
you don't sit and run the fuel pump for long periods at low power.  I chose
30 min. as an excessive taxi/hold condition.  The only way to know what temp
is acceptable is to test the system as installed and using the actual fuel.
Remember, mogas has variable vapor pressure with season and locale.  100LL
has consistent vapor pressure. You would also have to introduce an additional
vacuum source to simulate climbout with hot fuel.


Jeff-hotfuel.jpg

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Jeff-hotfuel.jpg