TOM & BOBBIE JORDAN wrote:
Paul: thought I'd give you an update on my roatry. I tuned it for high RPM
operation and got 4400rpm at 3/4 throttle. Tracy and I decided that is all I
will get until he burns in a new chip for my computer. My boost at that rpm
was 11. The engine ran smooth and I am sure if I could have tuned the
computer to deliver more fuel it would have accepted it. I am sure there will
be lots of debate about how much boost is too much. I am going to contact the
person I consulted with in putting this configuration together and I will pass
along the info. I hope to be off to the airport for taxi tests next
weekend..........Tom
Paul wrote:
I am worried about detonation. Listen to the engine with a stethoscope
while it is running like that. You may even be able to lengthen the
tubes
of the stethoscope and wear it while taking off. If you hear what
sounds like detonation back off on the throttle if you have enough
altitude. Fasten the "mic" of the stethoscope to the rotor housing
just above the top spark plug. One tube to each rotor housing.
Sounds like you have plenty of power to take off. You need to sneak
up on max power with that thing to be sure you are not getting
detonation
with those high boost levels.
4400 RPM static with with 3/4 throttle sounds like you are under proped
for all
that power. That is 2027 prop RPM which is alot for a fixed pitch static
prop
RPM at 3/4 throttle. You have a healty amount of HP there.
I would make the pulley on the blower larger and reduce the boost until
you get some hours in the air or monitor the detonation situation
closely as the RPM, HP and boost builds up with speed in the air.
A failed engine on takeoff can ruin your whole day.
You might monitor the engine sound with the stethoscope while doing high
speed taxi test as well. An old airline entertainment head set with new
tubes
would be a cheap stethoscope.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org