Subject: Vance's twin three rotor 4 place airplane.
From: Paul
Date: 6/26/1999, 11:41 PM
To: zz

Vance and Emily Jaqua wrote:

 Boy! the 18 inch hub with the tip velocity limit
squeezed at 36 is a fairly nasty hit on disk load.

Yes. I expected that but that is what we are up against.
If you want a decent power to weight ratio out of
the rotary we need to run it at 6500 RPM and 
that means we are very limited in fan diameter.

The hub needs to be big to enclose the rotary as we 
are also limited in the length of the e-shaft extension 
to mount the fan. Perry is currently running about a 
twelve inch long e-shaft extension.

We could use a drive shaft with a separate fan bearing
but now we are moving in the direction of weight and 
expense of a gear box. Perhaps a slight necking down
is possible say to 16 inch diameter at the fan hub.

Disk is a simplifying expression of course, 
and the usual quick look ignores the hub - usually to small
signifigance. Here we become equivalent to about 31
inch dia, and I feel that up and downstream area
should be kept close to uniform.

Reason for the 16-18 inch diameter core cowling.

 I put an imaginary
 small four place in one of my rough performance
 models with 1000 hp and this sort of disk loading.
 wing area about 110 sq ft flight weight 2800lb. Sea
 level top was 390 mph, best climb came in about
 200 mph at over 5000 fpm. 

Computed flat plate drag
eqiv was about 1.6 total at high speed (bottomed
out induced drag). 

Q [dynamic pressure] at 400 mph sealevel is a 
bit over 400 lb/sq ft. 

 I was not charging anything for internal
duct skin friction - with the 18 inch dia 
[core cowling] something  like the GE unducted fan 
springs to mind for direct Wankel drive.

GE found that was 20% more efficient than a ducted fan
but painfully noisey.


Some max possible thrust points for 31 inch equivalent 
diameter fan at 500 hp.

   speed      jet vel     delta v      thrust max 
       0        286         286            961  
      50mph     313         240            879
     100        344         197            799
     200        424         130            346
     300        525          85            419
     400        643fps       57fps         456

Fuel consumption for 1000 bhp would be pretty fierce
but with a turbo to hold a bit of that power to
higher altitude things look a bit brighter and
the structural loads from "Q" are more comforting
Vance


Great work Vance.  Thanks a lot. Saves me doing it.
If you are going to do a ducted fan this is the way
it should be done.

This is something like Racing Beat is developing and
durability testing those two 900 HP turbo three rotor
for. Pictures of these engines are on the ACRE NL 
web site.

BTW a Cessna Citation Jet burns 111 gals an hour.
At 750 HP the two.. turbo three rotors would probably
burn 63.5 gals an hour total. Cruise speeds would be close.
The cost of the rotary engines at $20,000 each would 
be one fifth to one tenth the cost of the turbofans
and as icing on the cake near double the range. 

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org