Subject: Vance's twin three rotor 4 place airplane.
From: Paul
Date: 6/27/1999, 11:19 PM
To: zz

Vance and Emily Jaqua wrote:


On Sun, 27 Jun 1999 10:28:56   Paul wrote:
BTW if the Mazda three rotor turbocharged engine 
can reliably generate
500 Hp for takeoff and 375 HP for cruise a ducted fan
twin could revolutionize air travel. The cost per seat mile
could be lower than the airlines and would beat the heck out
of a biz jet. The flying time would be better than
the low end biz jet on long trips as there could be fewer
stops for fuel. The cost of the airplane would be way less
than a biz jet. This is an outgrouth of the extreme simplicity
of the rotary engine and the ability of Mazda to mass produce
engine parts at low cost.

Less time would be wasted at the airport. It would be more
comfortable than being crammed into an airliner and you could get
much closer to your final destination with no need to change
planes.

The market for this type of airplane could be
unlimited. The demand for pilot training and IFR 
ratings could explode.
The demand for ATC service would dramtically increase.
Even the demand for rental cars at smaller airports would also
increase. Air taxi business would increase as well.

I have already stated this more or less when I first heard about the
three rotor turbo ducted fan project at Racing Beat.

There is absolutely no pie in the sky about this.

This is far more likely to happen than Williams coming up
with a low cost and efficient turbofan.

I think we are at the dawn of a new aviation era.


Paul Lamar


Paul - Gee! since it sems to have acquired the tag
as Vance's plane, I guess I better ring in with some
input. The scheme has a lot of merit - tho 400 mph
may be a painful stretch. 

On the planform -
turbofans usually weigh such a small portion of
aircraft weight that you can put them anywhere,
and out back helps noise level. With the Wankel
fan we don't have that much luxury, and I think we
would have to move them up forward to give us good
people range keeping CG safely forward - 
an underwing location like some of the other jet liners
would do this for us. High wing keeps them off the
ground, and a pusher prop/fan location shortens
the wetted area in the accellerated duct flow. I
would still like to unduct them - wear headset!
I will try the heavier weight, and a less optimstic
frontal area - them darn twins just bang into a lot
of air - also will try a medium boost to 12000 ft
Oxy and pressurized is a bag of worms - ask Lance
Vance


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Vances-Wnkpln.gif