Subject: Supercharger induced bending loads in e-shafts.
From: Paul
Date: 6/28/1999, 12:32 PM
To: zz

Ken Powell wrote:


     Paul,
     I have been following this thread for awhile and have been waiting for
     someone to address the issue of e-shaft reliability when you hang a
     supercharger on the accessory end.  It looks like the e-shaft would
     bend and cause an eventual failure.  The supercharger pulley sure
     looks like it is a long way from a supporting bearing.  Is this a
     correct accessment and if so, could you guess when this failure might
     happen (hours)?  I remember that it was calculated that the
     supercharger will only consume 22 HP, but did not see any calculated
     loads on the e-shaft.  BTW, Tom's installation is beautiful!

     Ken Powell


I have not run the numbers but as I racall Jon figured it out and
said it was about the same as an air conditioner compressor. He is
actually selling a boat engine with probably the same supercharger.
I am sure he will let us know if he breaks any e-shafts :-)

Be that as it may it is another good reason to go with a turbo.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org