Subject: Twin rotary airplane
From: Paul
Date: 6/28/1999, 9:53 AM
To: zz

Russell Kent wrote:

OK, I have two questions involving your twin rotary ducted fan design.

1. Can the rotor housing be assembled backwards to make an engine that is
plumbed mirror image?  Or maybe assembled with the eccentric shaft in
backwards so the power comes of the other end (then install the engine
backwards)? It seems that doing so would make the plumbing of the intake and
exhaust manifolds less Goldberg-esque on the port engine.

No! Sorry! With Vance's design it would make no difference anyway.
The cowlings and plumbing would be exactly the same if somewhat
unsymetrical.


2. The pylons themselves seem like good candidates for radiator locations.
You have a small frontal area and a large horizontal area.  Make the pylons
slightly "thicker", put a slot on the leading and trailing edges, and install
the radiator(s) horizontally (or nearly so).

As for Vance's idea of putting the engines under the wings: doesn't that make
the single-engine-out operation much harder?

Russell Kent


No more so than the aft mounting. Depends on how much clearance
between fan and fuselage. Well... maybe just a little.

Everybody send e-mail to Rich Trickel at Kis. This could happen!
What is Rich's email address Vance?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org