Subject: Knock sensors and 13b REW notes:
From: Paul
Date: 6/29/1999, 10:02 PM
To: zz

Turrbie@aol.com wrote:

If there are any of you that would like to interface Mazda's knock sensor
sending units with Paul's amp circuit, I could probably supply several. I
have been snatching them off of our imported 13b turbo II's, as they come in,
and squirreling them away. I haven't been following Paul's idea too closely,
but I have had the same idea of a pilot monitored knock sensor. I think that
it would make a lot of sense for my application in a Long EZ, especially
since the engine is way in the back.

13B-REW update:
I found out something rather interesting about the twin turbo this week.
There are actually two different engines: one for manual transmission and
another for automatics. I discovered this by chance while installing one of
our imported REWs, that had come with automatic trans, into a customer's car
that is a five speed. The main difference is in the rear end housing. The
automatic engine has the starter mounted similarly to an old Chevrolet unit,
against the block, with the starter motor extending forward and under the
rear leading spark plug. This necessitated having a large notch cast in the
rear end housing along with two additional threaded holes for mounting the
starter. The manual transmission engine is similar to the earlier 13Bs, with
the starter bolted to the back of the bell housing. Note that bell housing
bolt pattern for the REWs is slightly different from earlier engines.
Luckily, it was easy to put an automatic engine in a straight car, but the
end housing would need to be changed to make the swap in the opposite
direction.

If you are looking for a twin turbo for an aircraft conversion, I would
recommend the M.T. engine, since the rear end housing flange doesn't have
that rather large notch in it. (Less surface area to mount the PSRU to)

Last note: The customer's engine died from an inner O-ring failure after 85k
miles.
Bruce Turrentine


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org