Subject: Lip suction and ducted fans.
From: Paul
Date: 6/29/1999, 10:33 PM
To: zz

Vance and Emily Jaqua wrote:

Jeff Spitzer wrote:

Again, the thrust is THE SUM of Mdot*deltaV and the integrated pressures.
They are not separate nor can one be "converted" to the other.  As I said
before, the choice of the control volume determines the relative magnitude
of each.  Here's another one to shake things up.  If you choose the control
volume in a duct as the fan disk only then there will be NO (I repeat zero,
none) thrust due to change in velocity.  It will all show up in the
pressure terms.  If you draw the control volume a mile beyond the duct in
all directions then there will be essentially zero (not actually if you
really study aero) pressure terms.  Yet again, I defy you to define the
proper streamlines/cross sections to measure the thrust by change in
velocity only. Of course the pressures and velocities are related.

Jeff Spitzer

The pressure comes from moving the mass of air around, it does 
not happen by magic. The only tool you have to work with 
is the mass to fling around, and thrust and lift come from   
doing work in this way. I have been professionaly involved
with propulsion design and test most of my working
life from jets to rockets, and have had to provide
answers to some significant problems in this area.

In many environments you cannot measure thrust directly, 
and the technique is to measure and
integrate pressure area terms quite carefully -
you do not add other things in when you do this.

Rockets make thrust by using mass they have carried
along and expell it at the highest possible
 velocity. For jets and props you have the luxury of
being able to grab air and accelerate it (along with
very minor amounts of fuel you add to this mass.
I doubt that you will find many experts in this
field that will dispute these statements - Vance

Vance I want to move beyond this and come up with a blade
design for ducted fans. Do you have any coordinates on these
things. I think Perry is in dire need of a better blade
for his ducted fan. His fan diameter is 37.5 inches and
he would like to run it at 5500 RPM static.

Right know he is using a Clark Y airfoil with a 15% section
I would guess. Three blades about 3.5 to 4 inches constant
cord. The hub is about seven to eight inches in diameter.

Here is what Perry is saying about the situation quote.

"The duct is invisible as far as static rpm goes.  It's
around 4150-4200 static, increasing to 4400 at 90 knots.
The duct is increasing velocity to the fan plane, so I
don't get that much rpm increase unducted at 90 knots.

I would rather have 5000 rpm for takeoff, the two-blade
prop would do that, but I don't want to exceed 6000 rpm
during cruise.  Redline is 7000.

How about 100-110 HP and 4400 rpm, the real numbers?

End of Perry's quote.

I don't think this is enough HP to climb out of ground
effect. He needs higher RPM and more HP IMHO.

Can you help out with a better blade design?

Paul Lamar

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org