David Carter wrote:
Paul wrote:
David Carter wrote:
Paul wrote:
Turrbie@aol.com wrote:
If there are any of you that would like to interface Mazda's knock sensor
sending units with Paul's amp circuit, I could probably supply several. I
have been snatching them off of our imported 13b turbo II's, as they come in,
and squirreling them away. I haven't been following Paul's idea too closely,
but I have had the same idea of a pilot monitored knock sensor. I think that
it would make a lot of sense for my application in a Long EZ, especially
since the engine is way in the back.
Bruce Turrentine
Bruce,
I'd like to buy one ( . . . or, do I need one per rotor??? .i.e., two .
.) of those sending units. Where do I send my check?
I'm going to put this thing on my 1995 Ford Escort 1.9L engine which is
beginning to ping on 87 octane. I've recently switched to 89 which
doesn't ping - but will switch back to test the audio knock sensor -
should be interesting - if Mazda sensor will attach to the Ford block.
For the knowledge of the reading public, what do these sensors attach to
on the 13B?
David Carter, Nederland, Texas
There is a cast on boss on the late rotor housing just above the top
spark
plug. You can see the position in the picture on the ACRE NL web site.
Paul Lamar
David asks a follow-up question:
Would I be correct to assume that only turbo rotor housings have this
mounting point? Or, are the rotor housings common with the rotor itself
being either "lower compression" (for turbo) or "higher compression"
(for "normally aspirated")?
David C.
I can say the recess in the rotor controls the compression ratio
and not the rotor housing.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org