Turrbie@aol.com wrote:
In a message dated 6/30/99 6:57:57 PM Eastern Daylight Time,
rotaryeng@earthlink.net writes:
> Would I be correct to assume that only turbo rotor housings have this
> mounting point? Or, are the rotor housings common with the rotor itself
> being either "lower compression" (for turbo) or "higher compression"
> (for "normally aspirated")?
>
> David C.
I can say the recess in the rotor controls the compression ratio
and not the rotor housing.
Paul Lamar
The casting for the rotor housings are the same for turbo and non-turbo. They
only differ in some of the machining processes and the exhaust port liner.
The boss for a knock sensor is present on both of the later style rotor
housings. The bosses on the non-turbo housings have not been tapped and
milled flat.
David,
I would be happy to send you a knock sensor or two, but If you plan to use
them on an Escort, they will not be optimized for the engine's knock
frequency. I believe that the knock sensor is just a big quartz crystal. When
it experiences the frequencies associated with detonation, it generates an AC
voltage. Kind of like the quartz sparkers used to start outdoor grills or
pocket lighters. The crystal is manufactured to a certain dimension so that
it gives a strong signal when spark knock occurs. Different engine blocks
resonate and propagate the energy form spark knock at slightly different
frequencies. Most knock sensors are tuned to the specific engine in which
they are to be used. I would expect that these knock sensors would work in
another engine design, but not as well as a sensor tuned for that engine. I
can round up several different sensors from Toyota and Nissan four bangers.
Since the block design is similar to the Ford 1.9 (which I think is a Mazda
engine, not sure) you may have better results.
Bruce Turrentine
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org