Perry Mick wrote:
Paul wrote:
Vance and Emily Jaqua wrote:
The pressure comes from moving the mass of air around, it does
not happen by magic. The only tool you have to work with
is the mass to fling around, and thrust and lift come from
doing work in this way. I have been professionaly involved
with propulsion design and test most of my working
life from jets to rockets, and have had to provide
answers to some significant problems in this area.
In many environments you cannot measure thrust directly,
and the technique is to measure and
integrate pressure area terms quite carefully -
you do not add other things in when you do this.
Rockets make thrust by using mass they have carried
along and expell it at the highest possible
velocity. For jets and props you have the luxury of
being able to grab air and accelerate it (along with
very minor amounts of fuel you add to this mass.
I doubt that you will find many experts in this
field that will dispute these statements - Vance
Vance I want to move beyond this and come up with a blade
design for ducted fans. Do you have any coordinates on these
things. I think Perry is in dire need of a better blade
for his ducted fan. His fan diameter is 37.5 inches and
he would like to run it at 5500 RPM static.
Right know he is using a Clark Y airfoil with a 15% section
I would guess. Three blades about 3.5 to 4 inches constant
cord. The hub is about seven to eight inches in diameter.
Here is what Perry is saying about the situation quote.
"The duct is invisible as far as static rpm goes. It's
around 4150-4200 static, increasing to 4400 at 90 knots.
The duct is increasing velocity to the fan plane, so I
don't get that much rpm increase unducted at 90 knots.
I would rather have 5000 rpm for takeoff, the two-blade
prop would do that, but I don't want to exceed 6000 rpm
during cruise. Redline is 7000.
How about 100-110 HP and 4400 rpm, the real numbers?
End of Perry's quote.
I don't think this is enough HP to climb out of ground
effect. He needs higher RPM and more HP IMHO.
Can you help out with a better blade design?
Paul Lamar
Paul,
I just started playing with the prop program yesterday, to design a new
prop. If I narrow the chord from 4.0 to 3.75, and make the blades much
thinner, using only carbon fiber, I can get to about 4800 static with a
three-blade prop. [4 inch! Another good guess. :-) PL]
Perry why don't you take a look at three cut down Warp drive blades
and an adjustable pitch hub? The cord on those is about 3.5 or so.
They are 100% carbon fiber. If you mess up on the pitch is would
save you a lot of time. PL
100-110 hp during takeoff should be plenty for a LongEZ. Bill Freeman
think's he has only about 85 HP available at the rpm he's running at
takeoff. The LongEz was designed around the O-235, and that's still the
only engine Rutan "approves", about 108-115 HP at redline, not takeoff.
Bill is working on getting the acceleration curve on his plane to
compare with mine.
Sure I have more drag, but my guess is 15-25% more max, maybe less.
Also I have more weight, but I'm still under the original Rutan gross weight
with no passenger.
I agree about the blade thickness being a problem, the program shows
that. Any help Vance could provide would be welcome.
Perry
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org