Subject: Mazda Engine Rebuilds - "Quality Remanufactured Mazda Product"
From: Paul
Date: 6/30/1999, 11:53 AM
To: zz

Brian D. Cain wrote:

The previous post on the ignition timing doodah prompted me to bring up
something about Mazda engine rebuilds.  My friend, against my advice,
decided to up and spend $2200, at a local Mazda dealership, for a 'Quality
Remanufactured Mazda Product'.  For a month, while money for him was tight
and while the engine swayed back and forth on my engine hoist, it seemed
fine.

To our dismay, however, once everything was re-installed in the car and
t-shot to working order, it's got some problems:

1) Apparent oil in the overflow tank and coolant system all together
2) White, milky residue on the dipstick at all points
3) Oil that looks like coffee from Starbucks
4) Puffs of white smoke out the tailpipes

At first, I thought it was a crankcase ventilation problems since I had
re-done his
crankcase vent plumbing since the factory vacuum spider unit was removed.  I
yanked the hose off the factory oil filler neck and found it to have no
effect.   After
some playing around, I think I've nailed it down.  I believe this to be an
outer
water seal failure.  I believe water jacket water/coolant is leaking, either
by gravity
or by moving force/pressure when operating, into the oil pan, "mixing"
itself in
the oil.  I also believe this to be an inner water seal failure, as well, as
combustion
gasses and oil are straying into the water jacket and getting circulated
around.

Ya have' to understand -- There were *no* leaks when I put this thing back
together.

On my last two engine jobs I've done 200% in doing the job right and making
absolutely sure I wouldn't have some stupid leak anywhere; of any type.  
The same point goes for this guy's setup, as well.

Getting to the point, however, is this -- This *really* pisses me off.  One,
he bought
an engine from a dealership which already has 50/50 odds like flipping a
coin for having potential problems.  

Two, he wasted a considerable amount of money in
regards to what it would've cost him to replace any hard parts on his engine
and rebuild his in my garage.  

Then, three, after a few months of project work
and installation, the bloody thing doesn't even work right!! It has to be
removed, rebuilt, and all of that mess done all over again.

What's worse?  They wouldn't honour his warranty because he was an 18 year
old kid.

B


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org