Ken Powell wrote:

     On the one and only rotary rebuild that I have done I got this wrong
     and had the CAS off by one tooth.  I still don't understand what I did
     wrong.  However, the engine would run but not rev past about 2000 RPM.
     I thought that I had some of the smog or computer stuff hooked up
     wrong.  Finally, out of desperation, I moved the CAS back one tooth
     and the engine ran like a top.  Check this first if the engine will
     not run right.  Learn from my mistake; it was painful for a few hours.
     It took me all day to figure this out.

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org