Subject: Rebuilding at home [was Mazda Engine Rebuilds]
From: Paul
Date: 7/2/1999, 7:50 AM
To: zz

X-Mozilla-Keys:                                                                                 
Turrbie@aol.com wrote:

In a message dated 7/2/99 5:27:24 AM Eastern Daylight Time,
rotaryeng@earthlink.net writes:


 Unfortunately the 13B  rotor housing is slightly over three inches.
 You will need to mic this in several places so a 3 to 4 inch
 micrometer would be handy. Calipers would do in a pinch.
You may also need to mic the E-shaft but this is rarely worn
 as I understand it. The rotor bearing is just under 3 inches and
 the main bearing is about 1.75 inches.

 Looks like three mic's or adapter anvils to fit one.
 Perhaps you know someone that you can borrow them from.

 I would also check the e-shaft for run out with a dial indicator
 in vee blocks.

 Paul Lamar

If you don't plan to build several engines, It might be a better idea to take
the parts to the local machine shop for measurement. Bring a list of the
measurements to be made and leave a blank beside each one for the technician
to fill in his measurements. I can't see where this will cost more than one
hour of shop labor. $55.00?
Bruce T


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org