Subject: Who invented composite airplanes.
From: Paul
Date: 7/2/1999, 6:41 AM
To: zz

X-Mozilla-Keys:                                                                                 
Vance and Emily Jaqua wrote:



On Thu, 01 Jul 1999 09:12:46   Paul wrote:
Bill Freeman wrote:

Paul,

Ken Rand used a low modulus dynel (IIRC) knitted cloth
with epoxy resin to skin the foam which he used for wing
shaping over the wood primary structure.  The dynel added
*very*little strength due to both the low modulus and the
knitted weave and was eventually replaced with glass cloth,
which adds a LOT of strength over the original prototype.
Anybody remember how Ken Rand died?  As Paul recently
quoted about history - remember other's mistakes.

I believe the Piper Papoose was the first all composite airplane,
but there are also the Windecker Eagle and the Belanca
Skyrocket.  The Skyrocket "lived" at Charleston WV for
years, and was old in the middle 70s, I don't remember when
if first flew.  Heard they were flying it again recently.
Burt took the hotwiring of foam cores for wings from the
model airplane guys, but they used to cover the foam with
very thin balsa, since the only resin available long ago was
polyester and it dissolved the polystyrene foam.

Nah! I used epoxy resin, fiberglass and blue styrofoam on an antenna
mast design about 1958 or 1959. Our Chaparral chassis were epoxy
fiberglass in about 1963. I think epoxy goes back long before
that. The Windecker Eagle was the certified airplane from Midland
Texas I was trying to think of the name. IMHO Burt's main contribution
was making the canard stable enough to fly. The Wrights used
a canard of course. PL


The Papoose was flown for a while and eventually Piper
decided it would not be cost effective.  I think it still exists
in some museum somewhere.

Bill


The statement about Dynel is correct but was not
a factor in Ken's death which was classic flying
into weather without proper planning. I am pretty
sure that he ran out of gas in storm conditions
and crashed in the mountains. The structure of
those planes was primarily the wood spar which is
more than adequate - the glass adds a lot of
stiffness which can be both good and bad.

The Piper was purported to have the fuselage made
from a drop tank which might have been linen
phenolic, I think the wings were more classic
construction. A modern recreation is being marketed
without any composites. The early plane I remember
I think was a glass foamed wing with a conventional
fuselage ( my very imperfect memory thinks it might
have been called Jupitor).
The Bellanca Rocket is also struggling to be
revived. Somebody somewhere MUST be archiving all
 this good old history where we could access it.
 -Vance


Bellanca Rocket is looking at the Orenda big block Chev based
V8 for $110,000. Too bad for their sake a three rotor is not 
certified. I would love to have an experimental version 
with a turbo three rotor. Putting it together would take
one person five to ten years however

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org