X-Mozilla-Keys:
BCGARDNER@aol.com wrote:
Paul,
Here's the URL of a vendor I've never heard of before:
<<http://www.jay-tech.com/default.htm>> Why don't you take a look and see if
there's anything there of interest? They're in New Jersey.
Barry Gardner
The manifolds look interesting but they also look like they are tuned
for
8500 to 10,000 RPM. Perhaps one could extend the length of the runners
for 6000 RPM. They also look very heavy. A simple mandrel bent
aluminum tubing manifold 24 inchs long is all you need.
What pray tell is so hard about that? If you don't
want to have them welded up from aluminum tubing make them
out of blue foam and epoxy fiberglass. Make them plenty
thick to with stand back fires. :-)
That 1/2 inch thick steel exhaust flange shown must weigh a ton.
The throttle body is way too expensive. Use something stock.
>From the 1/4 mile times on the web site:
BEST TIME 1/4 MILE : 7.84 et's SPEED : 165 mph
CAR OWNER: David Turbo
This is however the quickest 1/4 mile time I have seen for a
turbo 13B two rotor running on alcohol and nitro. The car is 1800
pounds which is 200 pounds lighter than Abel Ibbara's
R100.
I am sure the engine is right around 700 HP.
No telling what this engine would do in a light weight rail.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org