X-Mozilla-Keys:
Brian D. Cain wrote:
From: Paul <rotaryeng@earthlink.net>
<snip, ouch!>
BTW if Mazda thought one detonation would destroy the engine there
would be no point in installing detonation sensors.
.. nor would it survive in a production vehicle, I don't believe ...
Again I want to emphasize the importance of an intake manifold
temperature gage on turbo or super charged engines. High intake
charge temperatures are a primary cause of detonation.
That is why the guys getting 700 HP out of a two rotor 13B are
running ice water intercoolers and alcohol fuel. Keeps the mixture
cool.
Bingo on that. I still run petrol/gas station fuel (ugh) per the vehicle
being
a daily driver, but I do utilize a custom-made air to water intercooler w/
a 7gal tank (Driver's side storage bin) with a submersed 1000gph/~12V/3A
marine bilge pump. My in-cockpit thermo-meter measures the temperature
of the tank. When I dump a 10lb back of ice in there and let it relate w/
the
water in there, to fill, I usually wind up with temperatures in the high
30F's to
mid 40F's after about ~30sec. The pump pushes cold water, through a set
of copper 1/2" hardline riveted to the underbody alongside the fuel lines,
to
the top-mount core (sealed aluminum) and fills it up. Intake air rushes
through
the top-mount core and the heat is exchanged off of the aluminum tubing
walls into the water. The water is then passed out to a front-mount heat
exchanger (Daihatsu radiator in this case -- hey, whatever works, right?)
and
is then passed back into the tank.
The results? After showing off a frosting-over top-mount core to some of
the
more experienced and technical racers at an event in Oklahoma Oct'98, I
ran the vehicle 8 times down the 1/4 track. I ran as high as 17psi of
manifold
pressure with intercooler tank temperatures in the high 40's to low 50's
after staging up and crossing the line. After everything was said and done,
even though I currently don't have an intake manifold temp gauge, I can tell
you that the upper intake manifold was still COLD to the touch; I mean
*really* cold.
All of these street-racer punk kids w/ air to air units just don't have a
clue, in
my opinion, on what they're truly missing.
As I recall Tracy measures the intake manifold temperature and that
is how he sets the mixture along with manifold pressure and RPM.
He does not rely on the O2 sensor.
Perhaps we could talk Tracy into displaying this temperature number on
the intrument panel.
Agreed. I guess this will be aftermarket gauge #8.
Paul Lamar
B
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org