I have been thinking of a way to effectively cool a
canard configuration for the rotary engine and I think this is
it.
This is a picture of Chuck Harbert's three rotor Velocity.
You are looking at the bottom with the front of the airplane
on the left. The rad is mounted horzontally below the engine
and the cooling air will be taken in from underneath P51 style.
The P51 type duct attached to the cowling is not shown of course.
The shiny aluminum thing you see
behind the rad is an oil pan made from left over diamond plate.
This could be reconfigured to optimise the exit air from the
rad. The air comes in from the bottom, slows down, goes through
the rad and finds it way up and over the engine and out the
back.
There is no conflict with the exhaust as it makes one
right angle turn and it too goes out the back.
In Chucks case it goes through a turbo first which of course
makes that ninety degree turn for you. All very tidy,
simple and neat.
The arm pit scoops can then be used for intercooler,
engine induction and oil cooler air.
This will work particularly well on side by side canards
like the Velocity and Cozy airplanes because of their
width. A large area, relatively thin and efficient radiator
can then be used.
I need to make a drawing.
Chuck orginally used the armpit scoop for both the engine
cooling radiator and the intercooler but found he had
to add this radiator to effectively cool the turbo three
rotor.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org