Subject: Cooling rotary engines in canards.
From: Paul
Date: 7/21/1999, 6:41 PM
To: zz

X-Mozilla-Keys:                                                                                 
Charlie and Tupper England wrote:

and an aux water tank someplace. Once you are in the air you
don't need to carry the weight of the electric fans and you don't
need to worry about them free wheeling and burning out
their bearings.

Paul,

I always thought overspeeding would be a problem, but someone on this
list pointed out recently that proper pressure recovery in the rad
plenum reduces airspeed to (I think) 40-50 mph. If this is close to
correct, why would the bearings go any faster here than in a car at 75
mph without a plenum?

As for weight, I'll bet most are <5 lbs installed, much simpler than
water tank/pump/plumbing, & you don't have to carry around water in the
tank or remember to top it off any time there's danger of a long taxi.

Is my logic flawed?

Charlie

Interesting message. Apparently the grill on a car acts like
a distributed or external diffuser. I doubt the airflow through a car
radiator is any where near its forward speed. Maybe not. Maybe that is
why the fan motor went out in my Caravan as I drive 80 to 90 MPH when
ever I can :-) Perhaps you could use the fan motor to help charge
the battery.

Would be fun to measure the air speed through a car rad.

Once the water is gone it don't weigh anything :-)
The plastic tank could weigh less than a pound.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org