Subject: First flight of rotary powered ducted fan.
From: Paul
Date: 7/22/1999, 12:34 PM
To: zz

Perry Mick wrote:

Had the FAA signoff on my plane last Monday morning.  Used a DAR,
who is really enthusiastic about homebuilts.

I took some more acceleration data before I flew this morning,
because I knew the original data I took with the Gtech meter was
flawed.  I took GPS position data vs. indicated airspeed, and from
that calculated acceleration.  It showed pretty good agreement with
theoretical calculations I've been doing lately that include the
drag of the plane and the drag of the duct.

Then I decided to find out once and for all what this thing would
do.  Well I'm pleased to report it did fly it this morning, and it
did climb out of ground effect.  Flight was a success for the
following reasons:

1.  I'm still here to write this report.
2.  It flew with direct-drive, my goal.
3.  Learned some things that couldn't be tested on the ground.

Rotated at 80 knots, take off was really smooth.  But it didn't climb
as well as I wanted, maybe 300-500 fpm (I can hear Paul now, "I told
you so"), so I entered the pattern to land.  My VSI was apparently not
working as it indicated 1500 fpm and was fluctuating wildly, but I was
definitely not climbing at 1500 fpm.  My intention if the climb rate was
sufficient was to climb to 5000 feet and practice holding a descent rate
and controlling airspeed.  I had to make three approaches before I got
it low and slow enough.  Landed long, and floated a little, but landing
was soft.

Also my oil temp got to 240.  Coolant temp was low in the normal
range.  So I have two mods coming, build that new carbon-fiber prop
to get me to 5000 rpm static vs. 4200 I have now, and improved airflow
through the oil cooler.

I was too busy flying the plane to take a lot of data, but did notice
4900 rpm at 110 knots.

It was a thrill to fly. The visibility in the Long-EZ is excellent.
I'm going to take some acceleration data unducted, and perhaps even
fly it that way.  Otherwise, it won't fly again til I make these two
mods.  I'm hooked now, got to get it back in the air.

--
Perry Mick
Duckt N7XR
http://www.mickaircraft.com/duckt.htm

I am greatly relieved that you are still alive Perry :-).
Congradulations.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org