Subject: Turbo exhaust manifold
From: Paul
Date: 7/23/1999, 11:33 PM
To: zz

X-Mozilla-Keys:                                                                                 
Twotikes@aol.com wrote:

I'm glad you like it.  I still have a little work to do on it though.  I will
analyze the stresses and creep in all areas.  I will also look at aero and
determine if height can be reduced.  Current height is 2".  I will probably
thicken the areas that carry seals once I calculate the membrane stresses.
In regards to your suggestion about the 4-bolt flange.  I think it might be
easier and lighter as you say but it has stress problems.  I think the reason
why the bolts are so far from the ports is to allow for grossly different
thermal expansion between the "thermal reactor" exhaust manifold and cool
side of block.  I will also evaluate removing part of the web in the
lightening pockets to add longitudinal flexibility for this reason.

Remember, sometimes it is easier to be the Birch than the Oak.  Wow, that
really sounded profound.  Then again maybe Mazda just wanted to make it
easier to get to the bolts ;-)  Hopefully some others will like the design
and it will make it cheaper for everyone.  Have a good weekend.  I'm starting
to get the Oshkosh blues 'cause I can't go.  Better, I have a family reunion
to go to.  I'm gonna have to educate the family about the end of July.

I am glad you are thinking about the thermal stress problem.
Good work Jeff.
I like it.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org