Subject: Bruce's location at OSH and the Ross problem.
From: Paul
Date: 7/24/1999, 9:35 AM
To: zz

X-Mozilla-Keys:                                                                                 
Turrbie@aol.com wrote:

In a message dated 7/22/99 9:44:31 PM Eastern Daylight Time,
rotaryeng@earthlink.net writes:


 > I just wanted everybody to know that I would be attending Osh this year.
I
 > don't have any plans to speak but I will be bringing a television and a
vcr
 > to show my video and answer any questions. This is assuming the parts
arrive
 > in time for the air brake compressor on the '51 bus.
 > BTW: Anybody that has the first version tapes, bring them and I'll
duplicate
 > the new version over it for free.
 > Bruce Turrentine

 Where can we find you Bruce?


I have no idea.  I will check in with Tracy Crook as soon as I arrive and
tell him where I'll be camped out. I will also probably spend some time at
his aircraft. He will have a new firewall forward system, including a new
four port engine that I built, his new redrive and fuel injection system.

BTW: When Tracy and I removed the Ross PSRU from his RV4 in preparation for
the new system, we discovered that the input shaft had beaten the end of the
e-shaft into a mushroom shape. It will take quite a bit of work to remove the
nut and counterweight. As with the consensus of most people in this
newsletter, I think that Ross really needs to install a thrust bearing for
the input shaft.
Bruce Turrentine

Yes. I am working on a revision to my drawing of a Ford C6 based PSRU to 
capture the input shaft and keep it from banging back and fourth.

The current drawing on the ACRE NL web site will be revised.

I think a simple snap ring in the right place will do the job.
I will check the thrust loads from the sun gear to be sure the 
snap ring will take them.

The Marcotte design I know for a fact does not have this problem.

BTW Bruce if you have any scrap parts you can let me have 
for drawing purposes please bring 
them along as I will be driving back to LA with the Dodge Caravan.
I still need another 13B rotor housing and an intermediate housing also
a few tension bolts to hold the mock up together. A late back housing
would be nice for the new motor mount bolt pattern. Also a late front
cover.

Also BTW did Tracy take the engine apart yet? I guess not with
that nut on there. I am curious how it held up for 800 hours.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org