Subject: Engine mileage how to inspect an engine.
From: Paul
Date: 8/3/1999, 8:05 AM
To: zz

X-Mozilla-Keys:                                                                                 
XXXXXX wrote:

Paul,

Do you think it has too high mileage for a rebuild ?

Gerry

If it was taken care of by changing the oil on a regular
basis and if it was never overheated ...no 150,000
is not too much for an overhaul.

The neat thing about a rotary is if the rotors are all right
the only other thing that may need to be changed is the rotor
housings. The e-shaft and the rest of it last almost for ever.
You may need to have the end housings laped.

Without looking inside you will never know for sure.
You could take it to a shop with a lift and take off
the exhaust manifold.

Rumor has it you can do a pretty good job
of inpecting by listening to the exhaust port as the
engine is turned over. I think Bruce or Brian mentioned
this. Perhaps they will elaborate. 

The other thing of course is you can see the rotor face 
and seals so you can partially inspect them through the exhaust
port. Look for broken apex seals and scared rotor faces.

Another trick, as I recall, is remove one plug from one  
rotor and place your thumb over the hole as you turn it over.
(Disconnect the coils.)

You should get one pressure pulse per e-shaft rev.. per rotor as
it turns over with the starter and none should be missing.
It takes three e-shafts revs with three pulses to test each rotor.

Watch the e-shaft and count the revs as you do this.
The starter may do it too fast so use a six volt
or nearly dead battery.

A pressure sensor hooked up to a low cost oscilloscope
would be a great rotary engine inspection tool.
Nice fat continuous  pulses of the same shape as 
the engine turns over would indicate an engine
in perfect shape. 

Pressure test the cooling system. If you get a slow leak
down the O-ring water seals could be leaking indicated the
engine was overheated at some point in its life and the
rotor housings could be "shrunk". Coolant of course will
come out the exhaust ports.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org