X-Mozilla-Keys:
Bill Freeman wrote:
Bill Freeman wrote:
Bill, do you have any info on sizing turbo's and intercoolers
for 230 HP at sea level and obtaining boost as a function
of altitude at standard temp lapse?
Assume a 2.6 liter engine. I have the Macinnes book.
Paul Lamar
Paul,
I understand turbo control systems reasonably well, but
am not really up on the proper selection of a turbo for
a particular application. I would listen to Jeff on this
one as he has "been there, done that" on turbo
selection for high altitude flight. If it was me, I would
select a "second throttle" type of manual
wastegate which permits your most adaptable computerized
voice/text programmable adaptive learning based turbo
controller (you!) to operate the system.
Good luck, but I doubt you want to really deal
with what it takes to go above about 20K. Things
start to get really difficult as you go above that, out of
proportion to the advantages, IMHO, for homebuilders.
Bill
I would like to break your friends altitude record :-)
My latest thought is to limit the gross weight and extend
the wing tips for better span loading. I think I can
do this with a few more nut plates that hold on the
current tips :-) I will also have to go on a severe
diet and lose 50 pounds.
Paul Lamar
Good luck, what is the aspect ratio of the KISS 4?
Well lets see the span is 29 feet and the area is 135
square feet so the constant cord is 4.65 feet.
Aspect ratio is 6.23. If I increase the span by adding
three foot long tapered tips I will be up to 35 feet.
The aspect ratio will then be 7.52 with somewhat of
a better planform. I might be able to get four foot tips.
I need to make a few carefull calculations and wear
a parachute :-) Perhaps I could use explosive bolts
and blow the other tip if one fell off :-)
The real important number is the span loading or load per
foot of span.
If I keep the payload weight down the span loading should
be pretty good.
The KIS has a very impressive structure with carbon fiber
spar caps and vacumme bagged prepreg honeycomb everywhere.
The empty weight is only 1200 pounds.
Probably the only real improvement would be to re-design
in 100% carbon fiber. I won't be doing that.
This is a *very* big portion of the reason that the LE
[Long Ez]
holds the record, plus the canard lifts, whereas your
tail pulls down. Not too significant at normal altitudes,
but you need every ounce of lift at 35K. Pretty cold
and scary up there. Not possible to get down in a
hurry, canopy ices you into IFR, you freeze and
the mixture movement between quitting due to overrich
and quitting due to overlean is about 1/32" travel.
Are we having fun yet?
I got cabin heat and a windshield defroster unlike an LE.
What mixture? We got EFI [Electronic Fuel Injection] :-)
Jim was trundling along at 30K + when he heard a
*HUGE* 'BANG' - from the sound, clearly something
in the airframe. Scared the crap out of him, but as he
clenched he realized that the engine was still running
and the A/C was flying along just fine. Couldn't
figure out what the huge BANG was. After sweating
bullets the whole rest of the flight, he discovered on
the ground that the canopy bubble had debonded from
the canopy frame (large CTE difference!) but was trapped
and was/ is fine. Sure made a loud noise - pulsing the canopy
right next to his ears.
Bill
CTE [Coeff. of Thermal Expansion]
Was it a steel frame? I got him there. The KIS plexi is bonded to
fiber glass everywhere.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org