X-Mozilla-Keys:
Andy Hecker wrote:
-----Original Message-----
This was seen at OSH on the Lancair Tiger Orenda V8 museum
peice. I think it is a good idea for turbo engines as
it minimise the length of the extra large diameter turbo
exhaust pipe winding its way around in the engine
compartment. The sooner it finds it way out the better.
<<snip>>
There will be a stainless steel radiused sheet metal
shield to streamline the exit air and protect the
firewall and the side of the composite fuselage
of course.
tigexhau.jpg
Paul Lamar
Paul,
How much drag from the exhaust exiting at 90 degrees? Maybe get the
exhaust gasses to exit straight aft just outside the boundry layer (and heat
shield!) facing aft - dump the drag and maybe pick up a bit of thrust?
Andy
Good question. I don't know. Probably no more than you would get
dumping
it out the bottom the same way.
Same drag reduction ideas go for a bottom exit.
I am going to need a lot of cooling with an air to air intercooler
and a larger rad because of the oil/water heat exchanger. On
top of all that about 230 turbo HP at sea level. This will allow me
to use a large area water rad under the engine and a vertically
mounted intercooler on the right side looking forward. Only one
water rad will simplify the plumbing obviously.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org