This is a picture of Chucks Inconel Turbo on his three rotor.

The manifold is also fabricated in Inconel with a less than ideal
location
for the waste gate. It should come out near the center at a 45 degree
angle.
But it appears to work so far.

It was done by  Mark Sedickas who owns Mark's Welding
and Fab in Graham, WA  Days-253-852-0540, evenings 360-893-5528. pager
206-314-6882.

Chuck Harbert wrote:
Mark did my exhaust manifold (turbo 20B) for about $300 (it was p/o a
lot
of other work). He gets scrap cuttings of inconel sheets from a local
source, and then he rolls it (min 2.5" dia) to make manifolds and
mufflers.- 
Chuck.


Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org