Subject: Grooves in rotor housings.
From: Paul
Date: 8/11/1999, 5:07 PM
To: zz
CC: Francesco Iannetti <iannetti@pop.mindspring.com>

Bob Darrah wrote:


PL wrote

About $200 each. $1200 for a 13B. Francesco told me why
the stock engine gets a groove in the rotor housing out near
the edge with the stock two and three piece cast iron seals.
The stock seals wear unevenly near the joint with the end
piece. That causes the groove in high mailage engines.
He claims his seals don't do that as they don't wear!


Do you want to hear my theorie on why the stock seals cut a grove
 in the rotor housing?  You don't have to answer that because I'm
going to tell you anyway.  After all my vast experience of rotary
overhaul (one), it seems that each apex has two leaf springs.  They
are inserted in such a way that they have 4 points of contact on the
seal itself.  Now, three of these are applying pressure on a seal
piece that is 3 (+-) inches long.  Not much pressure in psi.  Now
the fourth point is pushing on a piece that is .010 " long (where it
contacts the rotor housing), that is (roughly) 100 times the psi of
push trying to cut into the rotor housing than the long piece.  And
it does a good job of it.

Just theorie.
Bob Darrah

Sounds very plausable to me Bob. I wonder why Mazda has not
fixed that. In any event I am going to one piece seals
as that would no longer be a problem and I don't care about
low speed torque or emmissions for aircraft use.
One piece seals work well enough. I am interested in long
life and durability.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

1pcs-v-2pc-apex-seal-chart.jpg