Subject: KIS TR-4 cooling and motor mount.
From: Paul
Date: 8/15/1999, 5:36 PM
To: zz

This is a tight fit. I had to juggle things around for
quite awhile. It looks easy but I could not fit 
everything in and clear the motor mount tubes until 
I had the bright idea of raising the turbo charger. 
This has the benefit of better oil drain back from 
the turbo bearing housing.  I moved the intercooler
to the other side of the engine which gave me nice
long tuned intake pipes. It has has the advantage
of a single radiator which of course simplifies the
plumbing.

Surprisingly the KIS TR-4 four
place airplane has a smaller firewall and cowl than 
an RV6. this is the short cowl as I do not want to move
the engine forward as that would trigger a forward CG
problem. There is a five inch longer cowling available 
that is used for for the Continental six cylinder IO-360.
It requires a 40 pound battery in the tail cone.

In the process of doing this I had a good idea for measureing
the rotary engine exactly. I took a rotor housing and traced the
inside and the outside on a large piece of paper. I then
measuered it and found the center of the e-shaft. I then
positioned a front housing with the bosses for water pump
and alternator over the tracing of the rotor housing
and traced around the misc. bosses. I discovered the
engine is exactly as wide as it is high not counting
the pan. Actually if you count the plugs it is wider than
it is tall.


Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

kiscool.gif