Perry Mick wrote:
Paul:
Performed a second flight test this morning.
I replaced the defective VSI, and modified the exit duct
on the oil cooler, tripling the exit area. This also brought
the cowling exits closer to the prop by about and inch, and
I think this is causing some prop/cowl interference problems.
I've noticed a slight drop in top end rpm. I'll probably cut
the exit back to the F.S.(s) it was at originally, retaining
the increased exit area.
Confirmed this morning that climb rate is only 500 fpm at
80 knots and 4500 rpm. Climbed to 2500 feet, practiced
descending at 500 fpm. Takes 3600 rpm at 80 knots to
descend at 500 fpm. You can see that new prop is called
for, as this is pretty sluggish performance. You may
call this inefficient, and it may be, but remember I'm
running only 4500 rpm when the redrive guys are running
6000. Besides, I kind of like the "Cessna" performance
right now, while I'm getting used to flying the thing.
Fortunately, my oil temp is down, but not down enough.
It stabilized at 220 during climb, an improvement of 20
degrees. However, I expect it to go up when I increase
the rpm with the new prop. So it looks like oil temp may
be a continuing problem for me.
These canards must be extremely ez to fly, since both my
takeoffs and landings so far have been nearly perfect.
But I'm doing it in perfect conditions, first thing in the
morning with absolutely no wind. This morning I landed
on the first attempt.
May not fly again til I get that new prop. Any ideas on
improving the oil temp situation?
--
Perry Mick
Duckt N7XR
http://www.mickaircraft.com/duckt.htm
How fast did it go Perry?
About the oil cooler. Send us some more pictures.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org