X-Mozilla-Keys:
I was in Home Depot this morning eyeing flexible PVC (or ABS)
sched 40 water pipe for possible use as an intake manifold.
The dimensions are 1.5 inch ID 2.0 inch OD.
1/4 inch wall. Smooth inside. I would possibly connect it to
an aluminum flange and injector mount with hose clamps
and silicon hose. The other end of course would be connected
the same way to the intercooler. This would be a real easy
intake to fabricate. Eazy to tune as well. It is stiff enough
not to collapse yet flexible enough to move it around
to fit.
Any comments?
Paul Lamar
charles.harbert@fmglobal.com wrote:
Don't use it anywhere it's exposed to over 200 degF, because it softens and
melts at a low temp. I used some for my air intake and had to sheild it, and
replace it anywhere it came in contact with engine metal. I insulated it using
thick hose. Using normal turbo connection hose (Turbonetics, etc) is a very good
way to make a curving, light manifold. It's also a good insulator to keep engine
heat from going into the intake air.
Thanks Chuck.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org